Renewer oil for oiled and hardwax-oiled hardwood floors

Technical data

Physical and chemical properties

Safety requirements:
FLAMMABLE! For intended use only. Keep out of reach of children. Wear suitable rubber gloves when using the oil. Avoid contact with mucous membranes. If underventilated, use a respiratory protection. Do not inhale oil fumes. Avoid release to the environment.

Disposal:
Dispose of the preliminary water-soaked rags with oil remains in the tightly closed container.

Description and application

DESCRIPTION

Renewer oil for oiled and hardwax-oiled hardwood floors is developed specifically for periodic renovation of hardwood flooring, furniture, stairs, wall panels finished with any oil-containing finishes (natural oils, hardwax-oil, UV-oil) and restoration of protective properties.

The oil creates a thin oil-soaked wear and tear resistant film on wooden surfaces. It gives a water- and soil-resistant features to the surface.

The renewer oil is used when the hardwood flooring surface looks too “dry” (rough) or a main finish was worn off due to the heavy loads.

Periods of renovation depend on type of the facility and its’ loads:

APPLICATION

PRELIMINARY WORKS:

1. 
   Clean the floor from dust and litter using a vacuum-cleaner.
2. 
   Clean the floor with the hardwood flooring cleaner. Avoid overwatering, after the cleaning the flooring has to be dry in 2-3 minutes.
3. 
   It is recommended to provide the following climatic conditions: temperature +18°С to +25°С, relative air humidity 40 – 60 %. It is necessary to ensure a good air flow during the whole application and drying process.

MANUAL APPLICATION

Important! Shake well before use.

1. 
   Apply the oil to a renovated flooring surface with a resin trowel, a brush with rough bristles or a simple brush. Distribute evenly.
2. 
   When applied, rub the oil with clean, non-colored rags, remove the oil excess to avoid heavy stains and beads.
3. 
   Time to dry:
   For light loads (walking) – 12 hours,
   Time before using floors is not less than 24 hours.
   Maximal protective characteristics are available in a week.

AUTOMATIC APPLICATION

Important! Shake well before use.

1. 
   Apply the oil to a renovated flooring surface with a resin trowel, a brush with rough bristles or a simple brush. Distribute evenly.
2. 
   After the application, rub the oil using a single-disk white pad buffing machine.
3. 
   Time to dry:
   For light loads (walking) – 12 hours,
   Time before using floors is not less than 24 hours.
   Maximal protective characteristics are available in a week.

FLOORING CARE:
We recommend to use Coswick cleaner for oiled and hardwax-oiled hardwood floors.

TOOLS CLEANING:
Tools and dry oil remains can easily be cleaned with white spirit.

VIDEO

Surface renewal for oiled and hardwax-oiled floors care

Components